Skip to content
Viking Repair Marblehead, MA

Viking · Marblehead, MA

Oven Repair

Wall ovens and range-mounted cavities that will not hold heat, bake unevenly, or stall on the display. Igniters, bake and broil elements, door hinges and thermostats account for the great majority of it.

A stainless gas range with the oven door open, the convection cover visible at the back of the empty cavity and a rack propped alongside

On the phone

What gets described

  • Baking browning heavily on one side
  • Oven taking far too long to preheat
  • Door sagging so heat escapes across the top
  • Error code appearing and the cavity going cold

On the visit

What gets measured

  1. Cavity temperature against the set point through a full preheat
  2. Sensor resistance cold and at heat
  3. Bake and broil element continuity and visible condition
  4. Door hinge tension, gasket seal and the glass pack alignment
  5. Latch and lock travel where a self-clean cycle has been run

Flat $95 service call, credited in full against the repair. Nothing is ordered before you have agreed a figure.

What repairs run to

Bands, not quotes

Most jobs land inside one of these once the diagnosis is done. What you are given on the day is a fixed figure for your appliance, and nothing starts until you have agreed it.

Work Typical range
Igniter or burner assembly $270 – $660
Oven thermostat or heating element $250 – $800
Control board or touch panel $400 – $870
Dishwasher pump or control $300 – $1,280
Refrigeration fan or defrost system $290 – $710
Compressor or sealed-system repair $1,120 – $2,630

Flat $95 service call covering the visit and full diagnosis, credited against the repair once you approve it.

Also on the van

4.9/ 5

After a oven repair call

Drawn from 1249 reviews of this workshop.

  • Baking was browning heavily on the left. He found the bake element sagging onto the cavity floor, plus a hinge letting heat out along the top. Both replaced, and a sheet of scones finally came out even.

    Ansel B. · Old Town

  • Door had sagged enough to show light along the top edge. Both hinges were worn. He fitted a pair, adjusted the strike, and it shuts with a proper thump now.

    Pearl S. · Peach Highlands

  • The light stayed on with the door shut and we only noticed from the heat. The switch plunger had corroded solid. Small part, but he checked the nearby loom too since the salt had got at those terminals.

    Georgia N. · Swampscott

Tell us what it is doing

The model number and one clear sentence about the fault is enough to load the van properly. Flat $95 service call, credited against the repair.